Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
417
Views
0
Helpful
3
Replies

CW2K - "telnet not supported" when adding a device

todd-ferguson
Level 1
Level 1

‎03-03-2003 11:40 AM - edited ‎03-02-2019 05:32 AM

device suddenly failed on nightly netconfig backup, removed, readded the device, still no effect, changed hostname, tried a different interface address, same response. CW user is defined in TACACS+ and is the same user for all devices, config is the same config across all devices as well.

anyone seen this one before?

Labels:
0 Helpful
3 Replies 3

rmushtaq
Level 8
Level 8

‎03-03-2003 12:15 PM

What verison of RME?. Is Check Device Attributes displaying this telnet not supported message?

0 Helpful

todd-ferguson
Level 1
Level 1
In response to rmushtaq

‎03-03-2003 12:53 PM

Version is 3.1, yes I get that message after the Check Device Attributes.

0 Helpful

rmushtaq
Level 8
Level 8
In response to todd-ferguson

‎03-03-2003 05:11 PM

Sounds like CSCds82356

0 Helpful
Customers Also Viewed These Support Documents