CWM Installation Problem

[nazeerm]

I have been installaing Cisco WAN Manager 12.0.00 Evaluation copy on a Sun Fire 280R machine with Solaris 8. Installation halt towards the end.

Installation Progress bar move till the end & halt.

Installation Log message as follows.

"Adding the user svplusValue of useradd 9... Done

Setting the password for user Informix "

Can any one come up with a solution please.

Thanks,

Nazeer

[smahbub]

Hope you have followed the procedure well given in the document below. CWM Server Workstation Requirements

http://www.cisco.com/en/US/products/sw/netmgtsw/ps2340/products_installation_guide_chapter09186a008017a493.html#998779

[nazeerm]

Thanks for your response.Yes, I followed Installation guide. Installation Document says, good to have multiple partition for informix. Release Notes says Evaluation copy does not support muliti disk configuration for informix.

Even I did once with manualy created svplus & informix users and assign password and proceed with CWM installation. Nothing new.

Is it possible the evaluation copy is missing some of the file or something like that, don't knwo.