Disabling IPX MLS

[cadams]

This question was submitted yesterday on how to disable MLS IPX on a 6500 with an MSFC. There is a line on the switch that reads:

#mls

set mls enable ipx

I was told to disable IPX MLS on the msfc but when doing so it said that it was already disabled. How do I remove this line? "set mls enable ipx"

[steve.barlow]

On the catalyst switch, did you enter "set mls disable ipx"

eg.

Console> (enable) set mls disable ipx

IPX Multilayer switching is disabled

Console> (enable)

Steve

[cadams]

I will give that a shot. Thanks Steve.