02-11-2004 09:18 AM - edited 03-02-2019 01:31 PM
Can someone please tell me how to show the clock source for the ATM interfaces on an IMA card in a 7200? 'show controller ATMx/y' does the job on a 3600, but that command gives very different output on a 7200.
Thanks,
Bob
02-13-2004 02:42 PM
Clock is provided on the T1s. so you should do "sh controller atmx/y", not the IMA.
02-16-2004 06:37 AM
I had done that, but the clock source was not apparent. I've done some more digging and found that the value of "txtiming" tells you the clock source. A value of 0xA means Line and a value of 0xE means Internal.
Thanks for helping me find the answer to my question.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide