About bbrunette

bbrunette · 11-13-2018

Does this bug affect Nexus 9000 switches running in ACI mode or only those running native NXOS?

bbrunette · 07-09-2013

I have a L2L VPN with a pair of 5515's running 9.1.1 in Active/Standby as the remote VPN peer. I can get management traffic (ssh, snmp, radius, tacacs+, syslog) for the Active ASA to go through the VPN by using the "management-access inside" command...

bbrunette · 10-13-2004

While working on something else I discovered that all of our 1700 routers (1720, 1750, 1751) are listening on port tcp/2005. IANA lists this as "berknet". They are all running 12.2 or 12.3 IOS with feature sets ranging from IP Basic to IP/3DES/FW/I...

bbrunette · 04-27-2004

We use IMA to connect with AT&T's network and have had a couple of instances where they reset their Cisco equipment after seeing that the IMA group was in a "far-end temporary" sync-state. They say that the IMA group is functional but could experien...

bbrunette · 02-11-2004

Can someone please tell me how to show the clock source for the ATM interfaces on an IMA card in a 7200? 'show controller ATMx/y' does the job on a 3600, but that command gives very different output on a 7200.Thanks,Bob

bbrunette · 12-30-2013

Does the 64 bit version change the behavior or capacity of the voice gateway in any way other than adding SSH capability?Bob

bbrunette · 07-09-2013

Thanks Marvin. Please note that this is strictly a L2L VPN; there are no clients. And unfortunately even "failover exec" commands don't work, because we TACACS+ command authorization and the ASA has to talk to the TACACS+ server over--you guessed i...

bbrunette · 10-13-2004

Thanks, that does help. And it confirms what I was beginning to discover.Bob

bbrunette · 10-13-2004

I did some more digging and found that this port is open as a result of enabling telnet as an input transport on the aux 0 line.Interestingly, the same command produces different results on different platforms. On 2600, 3600 and 7200 routers no port...

bbrunette · 02-16-2004

I had done that, but the clock source was not apparent. I've done some more digging and found that the value of "txtiming" tells you the clock source. A value of 0xA means Line and a value of 0xE means Internal.Thanks for helping me find the answer ...

Member Since	‎03-28-2002 01:20 PM
Date Last Visited	‎08-15-2019 11:36 PM
Posts	18
Total Helpful Votes Received	5

User Statistics

User Activity

CSCvk30831 - BIOS upgrade may fail during install all

Management access to remote ASA standby VPN peer

Port 2005 open on all 1700's?

IMA Sync-state questions

Display IMA clock source on 7200

VG224 Firmware Question

Management access to remote ASA standby VPN peer

Re: Port 2005 open on all 1700's?

Re: Port 2005 open on all 1700's?

Re: Display IMA clock source on 7200