DYING GASP CONFIGURATION

[joyotuya1]

Hallo,

How can one configure dyim=ng gasp feature on Cisco 2811,2911 and ASR-1000 routers?

Regards,

Joy.

[jigojar]

Hi,

 configure the ethernet OAM with the and enabled the remote-failure option. you can find the feature dyinng-gasp under the remote failure.

interface GigabitEthernet0/0/1
no ip address
negotiation auto
ethernet oam remote-failure link-fault action error-disable-interface
ethernet oam remote-failure dying-gasp action error-disable-interface
ethernet oam remote-failure critical-event action error-disable-interface
ethernet oam