HI,  I am also facing the same issue. do we have any solution.     show snmp trace packet Tue Sep 17 21:34:44.212 IST Entering snmp_ltrace main.... 4154 wrapping entries (4160 possible, 0 filtered, 33100662 total) Sep 17 21:34:12.661 snmp/packet 0/RSP0/CPU0 30463033# t11 ERROR: Internal Dispatch failed at tp = 0 for reqID 1402973718 : (rc = 3487400448) 'snmp-lib-ipc' detected the 'resource not available' condition 'Not enough memory' Sep 17 21:34:12.661 snmp/packet 0/RSP0/CPU0 t11 ERROR: Internal Dispatch failed for 100.96.215.18,30876 (reqID 1402973718) 'snmp-lib-ipc' detected the 'resource not available' condition 'Not enough memory' Sep 17 21:34:12.661 snmp/packet 0/RSP0/CPU0 1659060# t11 ERROR: Internal Dispatch failed at tp = 0 for reqID 1402973750 : (rc = 3487400448) 'snmp-lib-ipc' detected the 'resource not available' condition 'Not enough memory' Sep 17 21:34:12.661 snmp/packet 0/RSP0/CPU0 1790358# t11 ERROR: Internal Dispatch failed for 100.96.215.18,30876 (reqID 1402973750) 'snmp-lib-ipc' detected the 'resource not available' condition 'Not enough memory' ... View more

Hi,   when we are using context we can able to see the BGP state alarms in Network Monitoring System(NMS) but we are not able to co-relate with VRF name. I can able to see the alarms co-related with ip address but does not with the vrf or RD.   is their anyway to co-relate the alarms with VRF Name or RD/RT. ... View more

HI,  so 2-port 40G will not support breakout on ASR 9006? ... View more

Tayyab,    in cisco document its clearly mentioned dont use both AC and DC.   ... View more

Hi,  what will happen if i am using both power source? can you pls share me the board design document in terms of power. ... View more

Hi, Why we are not suppose use mixed AC and DC power supply units in the same chassis. What is the reason behind this. ... View more

HI Genius,  anyone can help to clarify the above querys. ... View more

Hi George,        I would like to do the qinq for untagged frames with the specific vlan. the UNI interface will receive only the untagged packets from the neighbor and i would like to tag the untagged frame with the dummy vlan and  encapsulate with QinQ vlan. ... View more

HI    Aleksandar Vidakovic,  Pls correct me if i am wrong.  QSFP-40G-SR4 module is supporting 4-lanes. so what is means of lanes on the QSFP module so why we can not split up the 4X10G  from the 40G port. Pls confirm me once again that can we split up the 4X10G from the 40G port.   Below are the cards i am going to use:-   MOD CARD = 160G-TR LINE CARD = MPA-2X40GE MODULE = QSFP-40G-SR4 ... View more

Hi George,    Here i would like to map the qinq only for particular vlan in the interface. Is their any interface specific command.   the below command will work for my scenario   switchport trunk native vlan tag ... View more