E1 PRI Interface - multilink or not

[rabeder]

hi,

i have two cisco router , each of them with a e1 pri interface , which i want to

connect over a telco cloud for backup.

i have 30 b-channels which i can use.

if the two router connect, do they automaticly use all 30 b channels or have i to

specify "dialer load-threshold xy" - as it is with bri-int when i want to use the

two b-channels.

thanks for help !

[csco10341729]

You should be able to configure ppp multilink to do this automatically. Otherwise, "dialer-load threshold 1" should bundle them all (depending on IOS release i think). If that doesn't work, then use a really high "dialer idle-timeout" value to keep them all bundled.

D.