Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
253
Views
0
Helpful
1
Replies

Ether Channel in 3524

siljugpillai
Level 1
Level 1

‎01-11-2002 07:10 AM - edited ‎03-01-2019 08:00 PM

Hi,

I want to configure an ether channel in 3524 with 6509. There are 2 3524 configured in cluster mode. 3524 has two gigabit ports. So I am left with one port from each switch to configure channel(the other port is used for clustering). But when I configure channel with "port-group 1" in both the switches (gig0/2 in each switch), the spanning tree is bringing the ports down. So pls suggest what to do in this scenario?

Thanks and Regards,

Silju

Labels:
0 Helpful
1 Reply 1

bsivasub
Level 4
Level 4

‎01-14-2002 07:53 PM

you can't channel to two devices from a single 6509, if that is what you are trying to do.

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card