05-17-2005 03:54 AM - edited 03-02-2019 10:47 PM
Hi,
I wish to know if the WS-X6516-GE-TX line card can support half duplex command.
Aaron
05-17-2005 05:01 AM
No.. All ports on this card are 1000Base Full duplex.
05-17-2005 09:51 AM
Hi,
"No.. All ports on this card are 1000Base Full duplex."
Am I right to say that this card can only support either 10-full, 100-full and 1000-full duplex only?
Therefore, I will not be able to configure 100-half or even 1000-half duplex right?
Thanks
05-17-2005 12:52 PM
If the transmission speed on a 16-port RJ-45 Gigabit Ethernet port is set to 1000, duplex mode is set to full. If the transmission speed is changed to 10 or 100, the duplex mode stays at full. You must configure the correct duplex mode when transmission speed is changed to 10 or 100 from 1000.
Hope this helps,
Mark Turpin
05-17-2005 01:38 PM
Actually, I stand corrected. This card is a 10/100/1000 Base T card and can support half duplex as well.
Here is an output of sh port capability
Model WS-X6516-GE-TX
Port 3/1
Type 10/100/1000
Speed auto,10,100,1000
Duplex half,full
Trunk encap type 802.1Q,ISL
Trunk mode on,off,desirable,auto,nonegotiate
Channel yes
Broadcast suppression percentage(0-100)
Flow control receive-(off,on,desired),send-(off,on,desired)
Security yes
Dot1x yes
Membership static,dynamic
Fast start yes
QOS scheduling rx-(1p1q4t),tx-(1p2q2t)
CoS rewrite yes
ToS rewrite DSCP
UDLD yes
Inline power no
AuxiliaryVlan 1..1000,1025..4094,untagged,dot1p,none
SPAN source,destination
COPS port group 3/1-4
Link debounce timer yes
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide