07-08-2004 01:18 AM - edited 03-02-2019 04:55 PM
Can someone help with where I can find an explanation of the following results fields....
The command is dspalmcnt -ds1 <ln Number>
on a Cisco MGX 8250 FRSM 8E1 card running firmware rev 10.2.02
FRSM.a > dspalmcnt -ds1 2
LineNum: 2
lCVCurrent: 0
lCVLast15minBucket: 0
lCVLast24hrBucket: 1
lESCurrent: 0
lESLast15minBucket: 0
lESLast24hrBucket: 1
lSESCurrent: 0
lSESLast15minBucket: 0
lSESLast24hrBucket: 0
cRCCurrent: 0
cRCLast15minBucket: 0
cRCLast24hrBucket: 0
cRCESCurrent: 0
cRCESLast15minBucket: 0
cRCESLast24hrBucket: 0
cRCSESCurrent: 0
cRCSESLast15minBucket: 0
cRCSESLast24hrBucket: 0
sEFSCurrent: 0
sEFSLast15minBucket: 0
Type <CR> to continue, Q<CR> to stop:
sEFSLast24hrBucket: 1
aISSCurrent: 0
aISSLast15minBucket: 0
aISSLast24hrBucket: 708
uASCurrent: 0
uASLast15minBucket: 0
uASLast24hrBucket: 1378
percentEFS: 99
RcvLOSCount: 0
RcvOOFCount: 1
RcvRAICount: 1
RcvFECount: 23
07-19-2004 06:45 AM
May be this document might give you some ideas,
http://www.cisco.com/univercd/cc/td/doc/product/wanbu/8850px1e/release3/frsm/frsmmgmt.htm
07-19-2004 04:09 PM
Thanks for your tip but there is no info specific to understanding the "cisco-speak" results for the dspalmcnt -ds1 cmd.....Although I did pick up a number of other commands in this document that will be usefull..
Thanks
Warwick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide