Other Network Architecture Subjects

try to browse the device under ACLM edit after a fresh install with ROLEbase administrator enabled. Error message is "Exception while getting device attributes:IDL AclmModule/AclmException:1.0". There is no error before enable the ROLEbase administra...

HiWe have a 3500XL switch configured for port mornitoring for sniffer to capture traffics.Even though we have configured to SPAN both direction traffics, the sniffer is only able to see one way packets.We have changed the port setting to 10/half, but...

Just like an AUI port (DB-15) can be connected to a RJ45 transceiver , is there a converter/transceiver to connect to DB-60 serial ports?Thanksishwar

So Frame-Relay for a domestic WAN is becoming increasingly too expensive. Like a typical corporation all of our applications are housed in a Data Center in a hub and spoke fashion.26 remotes office/manufacturing have frame-relay with ports ranging f...

Can the Cisco 7200 series module Multichannel-T1/PRI 4-port module be configured to mux or load balance two seperate T1 circuits going to the same remote site for either MUX'd together or load balancing?Protocol is HDLC between the two routers.Thanks...

Does anyone know what QoS tools that the Plus feature set buys me that doesn't come inclusive w/IP Base (assuming 12.3 or later release) ??

When issuing a "wr m" on the active (designated) MSFC (Sup1A/MSFC1) an error on the non-designated MSFC is observed: "%PARSER-4-BADCFG: Unexpected end of configuration file", and any configuration changes are not replicated on the non-designated MSFC...

Can someone help with where I can find an explanation of the following results fields....The command is dspalmcnt -ds1 <ln Number>on a Cisco MGX 8250 FRSM 8E1 card running firmware rev 10.2.02FRSM.a > dspalmcnt -ds1 2 LineNum: 2 lCV...

Hi,first of all I would like to apologize for my poor english.I've set up a Webserver based on a Lamp (Linux Apache Mysql Php).Let's say that the webserver ip is 10.0.0.165.I would like to set up a Nat so that all incoming message from port 80 (http)...

Can anyone point me to a good tutorial on diffserv? We have a telephone company that wants me to implement diffserv so they can connect PBX's over the WAN. But I am a newbie at this, and they can't provide any sample router configs.

Hello ,Would someone send the link in cisco site for how to configure the two No's of 6509 for Redundancy & Load balancing. Pls note that each 6509 comes with Redundant sup engine and OS will be hybrid OS .I'm looking for the document how to config...

exchange server 5.5. I have implemented NATand access-list to permit mail through theNAT interface. What stratles me is that the 64 k line seems to be at peak use all the timeand I dont believe this is the mail trafficwhich is causing this. How can I...