How can I configure no service pad command in CatOS?

[arryok]

hi, i'm a network engineer in japan.

i need a help from you. i wanna configure no service pad command in CatOS.

i can't find any set command in WS-C4003 Software, Version NmpSW: 6.3(2a).

and what's PAD(packet Assembler/Disassembler)??

also, i can't set telnet password in CatOS.

i would appreciate your help.

thanks.

[Georg Pauwen]

Hello,

AFAIK, the service pad only applies to Cisco IOS, and there is no equivalent fo this in CatOS.

As to setting the password for TELNET sessions, set the password first:

set password xxxx

set enablepass xxx

and then define the authentication for the TELNET sessions (depending on what you use, the example below is for TACACS):

set authentication login tacacs enable telnet primary

Regards,

Georg

[arryok]

thank you very much.

i appriciate your help.