how to configure Link Channel on Cat6K

[aessome]

Hello,

i am trying to connect two building via Laser and link channelinzing:

the network look like this:

Bld A(CatOS) Bld B (IOS)

Cat6K------ 100 Mbps Laser ------ Cat6K

| |

Cat6K------ 100 Mbps Laser ------ Cat6K

I wannt to channelize this in 200 Mbit Laser . cann some one tell me how to configure this on my Cat please? my laser supported only fastethernet Link, one Bulding have catos and Bulding B get IOS on both Cat6K

Thanks for any suggession

[frejac]

In short, if I remember correct:

CatOS: "set port channel (ports) mode desirable "

IOS: Create a port-channel interface (Po1 for example) and enter "channel-group 1 mode desirable" at the physical interface.