04-05-2006 03:57 PM - edited 03-03-2019 02:40 AM
Help
How can I enable dot1x multiple-authentication on 2948G. The image is 8.2(GLX).
Thanks in Advance
Matt
Solved! Go to Solution.
04-06-2006 03:45 PM
I am quoting it (see below) from the link I sent to you in the previous post. Based on that it looks like it's supported on the 2948G switch
The Cisco Catalyst® Operating System (Catalyst OS) Software Version 7.5(1) for the supervisor engine supports the Cisco Catalyst 6500 Series and Cisco Catalyst 4000/4500 Series multilayer switches (including the Cisco Catalyst 2948G, 4912G, and 2980G-A switches).
Pls. rate all helpful posts.
HTH,
Sundar
04-05-2006 07:53 PM
Matt,
AFAIK, dot1x multiple host authentication isn't supported on 2948G switch.
HTH,
Sundar
04-06-2006 09:43 AM
Thanks for the response.
Any other product other than Cat6500 that supports this?
Thanks
Matt
04-06-2006 09:53 AM
Matt,
3550/4500 switches support multi-host feature. There may be more products out there.
Pls. rate helpful posts.
--Sundar
04-06-2006 02:33 PM
Hello Sundar,
Thanks for the response.
Multi-host does not give me what I want. I am looking for set port dot1x mod/port multiple-authentication which will force every mac on the port to undergo dot1x authentication. In the case of Multi-host only one of mac's need to authenticate - all the rest ride in for free.
I did locate a version 8.1 that supported this feature - can you please confirm if this is true.
Thanks
Matt
04-06-2006 03:21 PM
Matt,
Yes, the multiple-authentication feature is supported in 8.1 version. It appears it was introduced in version 7.5(1)as described in the following link.
http://www.cisco.com/en/US/products/hw/switches/ps708/prod_bulletin09186a0080125da0.html
Pls. rate all helpful posts.
--Sundar
04-06-2006 03:38 PM
Thanks again Sundar
Will it work on 2948G - according to 8.1 Command ref manual it does. Could you please confirm.
Thanks
Matt
04-06-2006 03:45 PM
I am quoting it (see below) from the link I sent to you in the previous post. Based on that it looks like it's supported on the 2948G switch
The Cisco Catalyst® Operating System (Catalyst OS) Software Version 7.5(1) for the supervisor engine supports the Cisco Catalyst 6500 Series and Cisco Catalyst 4000/4500 Series multilayer switches (including the Cisco Catalyst 2948G, 4912G, and 2980G-A switches).
Pls. rate all helpful posts.
HTH,
Sundar
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide