Hi
Firstly thanks everyone for your replies.
switch(config)#ip routing
result:
bl-sw-38(config)#ip routing
^
% Invalid input detected at '^' marker.
I've attached teh outputs of "sh version" and "sh run"
ip ? :
bl-sw-38(config)#ip ?
Global IP configuration subcommands:
access-list Named access-list
accounting-list Select hosts for which IP accounting information is
kept
accounting-threshold Sets the maximum number of accounting entries
accounting-transits Sets the maximum number of transit entries
address-pool Specify default IP address pooling mechanism
alias Alias an IP address to a TCP port
default-gateway Specify default gateway (if not routing IP)
dhcp Configure DHCP server and relay parameters
dhcp-client Configure parameters for DHCP client operation
dhcp-server Specify address of DHCP server to use
domain IP DNS Resolver
domain-list Domain name to complete unqualified host names.
domain-lookup Enable IP Domain Name System hostname translation
domain-name Define the default domain name
finger finger server
ftp FTP configuration commands
gdp Router discovery mechanism
gratuitous-arps Generate gratuitous ARPs for PPP/SLIP peer addresses
host Add an entry to the ip hostname table
host-routing Enable host-based routing (proxy ARP and redirect)
hp-host Enable the HP proxy probe service
http HTTP server configuration
icmp ICMP options
igmp IGMP global configuration
local Specify local options
name-server Specify address of name server to use
radius RADIUS configuration commands
rcmd Rcmd commands
reflexive-list Reflexive access list
security Specify system wide security information
source IP source
source-route Process packets with source routing header options
sticky-arp Allow the creation of sticky ARP entries
subnet-zero Allow 'subnet zero' subnets
tacacs TACACS configuration commands
tcp Global TCP parameters
telnet Specify telnet options
tftp tftp configuration commands
Hope this helps
Thanks
Dan
