01-06-2003 12:20 AM - edited 03-02-2019 03:57 AM
Hi
When I use "show proc cpu",I can get a PID of a process.
But how can I kill the process?
01-10-2003 07:54 AM
As far as I know, there is no command in the Cisco IOS to kill a Process. Hence I would say, its not possible to kill a process on a cisco router.
05-17-2024 02:17 PM
If you are on IOS XE device you might be able to try the below command. You may need to try different "locations".
"request platform software process terminate r0 69 kill"
05-20-2024 11:04 PM
Hello,
the exec command 'clear sockets <pid>' used to be around...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide