01-10-2006 10:51 PM - edited 03-03-2019 01:23 AM
Hi folks.
I've just packed up one (of two) Cisco Catalyst Express 500 switches.
I've configured the switch with two VLANs, including the preinstalled one.
So, I now got two VLANs in this switch, VID 1 and VID 500.
I've also configured port 24 to be a member in VID 500.
An optical fiber is connecting this switch with the rest of the LAN and this is connected to the first of the two fiber modules.
So, so far so good. The traffic in VID 1 is running just smooth and I got no problems. Now my question.
I would like to TAG the fiberport with 500 so the packages belonging to VID 500 is beeing correctly sorted in the switch at the other side of the opticat fiber. How can I do that?
Solved! Go to Solution.
01-10-2006 11:53 PM
Hello,
you have to configure the uplink port role as "Switch". This should take care about it. Have a look at
on how to assign port roles.
Hope this helps! Please rate all posts.
Martin
01-10-2006 11:53 PM
Hello,
you have to configure the uplink port role as "Switch". This should take care about it. Have a look at
on how to assign port roles.
Hope this helps! Please rate all posts.
Martin
01-12-2006 02:29 AM
Thanks for your help. Now I can use both VID 1 and VID 500 over the optical fiber.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide