Other Network Architecture Subjects

Our customer has a Cat6509 switch with one faulty WS-X6148-RJ-45 module. The "show module" commands shows there is an sub module WS-F6K-PWR on it. Can I order a replacement module to WS-X6148-RJ-45 together with PoE sub-module (for ex. WS-X6148-RJ45V...

If I configuring intervlan routing on my 3550, by giving the vlans ip addresses, how do I get these different vlans to go the the internet via my internet router, do I need to put a valid ip on my router and then just add a default route to this on t...

0.does span have any standard ,like ip's is rfc791？1.if i use a low bandwith port to monitor a high port ,what result i will get?2.how dose span influence the mathcine perfomance?

Dear Sirs, Please teach it about a mention of specifications list.1. Are "Switch Fabric" ,"Switching Capacity" and "maximum forwarding bandwidth" the same meanings?2. Are "Forwarding Rate" and "wire speed forwarding rate" the same meanings?Best regar...

hiwhich is the newest Release as a .tar filefor Cisco Catalyst WS-C3550-12T ?at the moment I have Release 12.1.22-EA6 installed.kind regardspiotr

Customer is experiencing long " ping " response time from his2924's management interface.His values are around avg/max 6/124I have tested in our lab with nothing else connected as my PC and I got avg/max 5/50msCan somebody explain these values ?Tha...

When use "redistribute static" in OSPF OR eigrp, does it also redistribute connected networks?When use "sh ip eigrp topology", the entries with "via RStatic" indicate a redistribution of static routes, corret?

When use "sh ip bgp", how to tell how many entries are in the BGP routing table?

I have 2 core Catalyst 6500s both with redundant SupII's. I want to use all 4-ports on each switch for a Gigachannel connection. It looks like 1 port on each SupII module is put in standby mode and can't be part of the Giga-channel connection.Is th...

Hi,I have a 7206VXR (NPE-G1) processor with 1GB of memory running the 12.3(15a) IOS code. I have about 215 frame relay subinterface with EIGRP enabled. I have noticed that when a single PVC goes down and then it comes up the IP-EIGRP: PDM process id ...

Hi everyone,I am getting the following message when I try to configure the gig1/2 interface which is on Sup mod 1 of my 4507 switch.router(config)#int gig1/2% WARNING: Interface GigabitEthernet1/2 is usable/operational% only when this is the only sup...

Any know the differnce?switchport trunk allowed vlan exceptswitchport trunk allowed vlan remove?

Cisco 2600. How do I distribute traffic between 3 logical subnets on 1 internal interface, or do i need to buy another ethernet interface? thanks

I have a 6009 core router. The MSFC is running on 12.1(19)E1 software. I would like to upgrade since this is very old software. I don't have much experience with the 6009. This router has two parts the MSFC and the switch as I'm sure you all know. Do...