01-04-2010 04:21 AM - edited 03-03-2019 05:49 AM
Is there any solution to test that an implemented QoS (priority,..) works fine after configuration?
For example: my boss want to see if the QoS implemented in my border router works fine. But he don't know how to read packet sniffer like wireshark, Ethereal.
Best regards
01-04-2010 06:24 PM
have a look at the following document which contains some QOS concepts and show commands that
might help you
https://supportforums.cisco.com/docs/DOC-8373
good luck
if helpful Rate
01-06-2010 11:54 PM
How about QPM?
I have not ever used it.
11-14-2018 09:56 AM
This link is dead.
01-05-2010 07:32 AM
iantra123 wrote:
Is there any solution to test that an implemented QoS (priority,..) works fine after configuration?
For example: my boss want to see if the QoS implemented in my border router works fine. But he don't know how to read packet sniffer like wireshark, Ethereal.
Best regards
In addition to Marwan's excellent link, it depends what you mean by testing.
If you want to show your boss that packets are being marked etc. then the doc has commands to show you that. But the real test of QOS is whether or not you are getting the service you expected for the different types of traffic you are marking. Is there some issue with the speed/throughput of your traffic ?
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide