I am unable to run encapsulation command on router configuration

[vinuthatr1996]

Hi Everyone,

I am having the same issue on router configuration. I am getting an error when i run the code .

"Router(config-subif)#encapsulation dot1q.90"

AND 

how to complete these tasks. 

Can some one help here please. 

[M02@rt37 · Accepted solution]

@vinuthatr1996,

This command under Gig0/.90 is wrong

The good one: encapsulation dot1q 90

https://ciscotracer.wordpress.com/2015/03/27/routage-inter-vlan-partie-12-router-on-a-stick/

[MHM Cisco World]

encapsulation dot1q 90

This correct one 

And friend in feature if you have issue with command use ?

How 

Encapsulation? 

See which available option you have then use again? 

Until you finish command 

[vinuthatr1996]

Thank you. 

Do u have the solution for one more pic which i have attached? 

[MHM Cisco World]

Sorry which one?

[vinuthatr1996]

This is the problem statement. I have tried completing it till task 2. 

Task 3 and Task 4 i am not getting any idea how to do it. 

[MHM Cisco World]

WoW good task
but sorry this cant be done in Packet tracer 

[M02@rt37]

Agree with you!

[vinuthatr1996]

Okayyy.... Then how to do it?