I do 'router isis' but I get 'protocol not in this image'

[news2010a]

C2610, IOS 12.3.

I've searched this on forums but I couldn't find the answer:

I attempt to do 'router isis' but IOS returns 'protocol not in this image'. How can I solve this ? I would like to work on ISIS redistribution labs against EIGRP, OSPF, etc.

[jackyoung]

Follow the feautre navigator as below. It requires adv. enterprise service, enterprise, telco, adv. ip, sp or ip voice feature set. Please confirm you are using the above feature. If you are using IP based or Plus only, it can't support. Please advise the IOS release or the provide "sh ver".

http://tools.cisco.com/ITDIT/CFN/

Hope this helps.

[news2010a]

Thanks for info. hmmm... I need to search it more, but so far it seems my image can't do ISIS...

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-I-M), Version 12.3(12b), RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2005 by cisco Systems, Inc.

Compiled Thu 31-Mar-05 19:08 by jfeldhou

Image text-base: 0x80008098, data-base: 0x80CCAA68

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

ROM: C2600 Software (C2600-I-M), Version 12.3(12b), RELEASE SOFTWARE (fc2)

RouterC uptime is 8 hours, 16 minutes

System returned to ROM by power-on

System image file is "flash:c2600-i-mz.123-12b.bin"

cisco 2610 (MPC860) processor (revision 0x203) with 28672K/4096K bytes of memory

.

Processor board ID JAD05390K1C (3082946085)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

1 Ethernet/IEEE 802.3 interface(s)

2 Serial network interface(s)

32K bytes of non-volatile configuration memory.

--More--

[jackyoung · Accepted solution]

You router is IP based only feature set that can't support IS-IS. Try to upgrade it to advanced IP service to enable IS-IS.

Hope this helps.