03-31-2013 05:01 PM - edited 03-03-2019 07:01 AM
Hello I have a problem and I need to connect 3 different vlans that have a full class c address to each other. I am also using a spanning tree which I am allowed to use any address I like so I already set it up. Any help would be greatful. I am not really good packet tracer as I am using an example in my work :/
I added the file that I am using in the Packet tracer.
03-31-2013 05:17 PM
in short
Right now only pcs in their vlans can ping eachother. I need pcs from vlan 5 to ping the other vlans and the same should happen back.
I understand that I need something in my router to make them talk to one another. in the file I listed all the commands that are running at the start. If there is something I need to add please let me know.
03-31-2013 11:03 PM
Hi Jack,
A small correction on your DHCP scope configuration. It looks like you have configured wrong default gateway's on your DHCP scope.
Your Current Configuration
ip dhcp pool vlan5
network 198.1.253.0 255.255.255.0
default-router 195.1.253.254
ip dhcp pool vlan10
network 198.1.255.0 255.255.255.0
default-router 195.1.255.254
Modified DHCP Scope Configuration
ip dhcp pool vlan5
network 198.1.253.0 255.255.255.0
default-router 198.1.253.254
ip dhcp pool vlan10
network 198.1.255.0 255.255.255.0
default-router 198.1.255.254
Once you correct this verify the PC's are picking the correct gateway address and try pinging between the vlans. That should work.
Regards
Najaf
Please rate when applicable or helpful !!!
04-01-2013 12:13 AM
Hi Jack,
Yes Just tested the same on your devices and all devices are able to ping each other.
As Najaf said you need to modify the DHCP scope configuration and everything should work.
HTH
Regards
Inayath
04-01-2013 02:25 AM
Thank you very much. I figured it was a little error. Thanks again!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide