Other Network Architecture Subjects

Hi,I have 1100 and 1200 access points connected as root bridges on cat4503.__________________________________The Gbic interfaces on cat4503 are configured like this:!interface GigabitEthernet3/1 description AP001 switchport trunk encapsulation dot1q ...

Hi,I installed a redudancy sup720 sup-engine on my 6509. But it is not working properly. How can I make the redudancy engine work properly?At first I configured redudancy mode like this:redundancy mode sso main-cpu auto-sync bootvarI place this engi...

Hi,There are three offices which are connected together thru Metro Ethernet. How to trace out which one the opposite router is?Moreover, how to testing the available max bandwidth?Regards,Samuel

Hi all, I am setting up a vpn connection in my office, rather than having this on my dmz, can I have it on another site usign NAT, and permit the relevent ports to it ?

Hi all,I am having the following need:Consider there three routers R1------area0-----R2-----area1-----R3Area1 is nsssa.In R3, I have the following configs:router ospf 100 redistribute static area 1 nssa network 10.1.1.0/24 area 1ip route 150.x.1.0...

If I have 2 physical e1 links on my router, and want 2 1 mb lines on each, do I use 2 channel groups and timeslots 1-16 on each, can anyone help on this ?

Hi,what is the different between facility and severity?How to customize the facility local7?Regards,Samuel

Hi all,We are going to replace the faulty SFM2s with NEW SFM2s on Catalyst 6509. and actually faulty SFM2s are installed on slot 5 and 6 on Catalyst 6509. My question is , Is that support OIR for TWO SFM2s at a time ?Welcome any posts...TIA...

How can i advertise WPAD entries through CISCO DHCP, i have done it in WINDOWS DHCP but not sure wether cisco DHCP supports it or not, can anyone please help?Cisco DHCP is running on Catalyst 3560.Thanks,Muhammad

Which type of OSPF network requires manual configuration of OSPF neighbors?A. broadcast multi-accessB. nonbroadcast multi-accessC. point-to-pointD. point-to-multipointregardsNeo

Hi All,I am upgrading the Cisco IOS on Catalyst 6509E for the first time.I have read the procedure but still am confused.Would like to clarify my doubts?1. I can see the IOS image in both the sup-bootflash & sup-bootdisk[ 12.2(18)SXF4 ]2. When I perf...

Hi all,I cannot figure out why a new Cat2950-24 suddenly switches to rommon mode a few minutes after boot and renames all the three config files (config.text, private-config.text and vlan.dat) in config.text.renamed and so on.Bug toolkit doesn't help...

when providers set e1 up, is it normally an end to end connection ? is it like a point to point ?