Hello,
I've got a router at a customer's site that uses ISDN as a backup line. For some reason, I was able to successfully make a call this morning, but then trying again right after that call, I get the following error message when I try to make an isdn test call interface bri 0:
*Mar 5 01:47:58.143: ISDN BR0 **ERROR**: host_disconnect_ack: Call rejected cause Temporary failure(0x29) call id 0x8007
The ISDN line is a standard Point to Multipoint ISDN line from the Deutsche Telekom here in Germany. I've already had a technician on-site to look at the line, calls in and out work perfectly fine, but the Cisco router can't make a test call properly. I've already replaced the router because the thing wouldn't initiate a call when the main SDSL line went down.
Can anyone give me a hint?
Here's debug isdn events and debug isdn q931:
router#isdn test call int bri 0 [testnumber]
router#
*Mar 5 02:00:38.379: ISDN BR0 EVENT: UserIdle: callid 0x800A received ISDN_CALL (0x0)
*Mar 5 02:00:38.379: ISDN BR0 EVENT: process_bri_call: call id 0x800A, called_number [testnumber], Guid C928DE00800D speed 64, call type DATA, bchan -1 clng_num none
*Mar 5 02:00:38.383: ISDN BR0 Q931: Applying typeplan for sw-type 0x1 is 0x0 0x0, Called num [testnumber]
router#
*Mar 5 02:00:44.385: ISDN BR0 Q931: Ux_DLRelInd: DL_REL_IND received from L2
*Mar 5 02:00:44.389: ISDN BR0 EVENT: process_rxstate: ces/callid 1/0x800A calltype 1 HOST_DISCONNECT_ACK
*Mar 5 02:00:44.389: ISDN BR0 **ERROR**: host_disconnect_ack: Call rejected cause Temporary failure(0x29) call id 0x800A
router#
and here's the relevant config data:
router#show run int bri0
Building configuration...
Current configuration : 251 bytes
!
interface BRI0
description Dial Backup Interface
bandwidth 128
no ip address
encapsulation ppp
dialer pool-member 2
isdn switch-type basic-net3
isdn twait-disable
isdn point-to-point-setup
ppp authentication chap callin
ppp multilink
end
gs01-kempten#show run int dia2
Building configuration...
Current configuration : 420 bytes
!
interface Dialer2
bandwidth 128
ip unnumbered Loopback0
ip access-group 120 out
encapsulation ppp
load-interval 30
dialer pool 2
dialer string 0[testnumber]
dialer string [testnumber]
dialer watch-group 1
dialer-group 2
ppp authentication chap callin
ppp chap refuse
ppp pap sent-username user@realm password pass
ppp ipcp dns request accept
ppp multilink
no cdp enable
end
dialer watch-list 1 ip [watched IP] 255.255.255.255
dialer watch-list 1 delay route-check initial 600
dialer watch-list 1 delay connect 180
dialer watch-list 1 delay disconnect 120
access-list 120 remark "deny voice via Backup"
access-list 120 deny ip any [voice net] 0.0.255.255
access-list 120 permit ip any any
We have this exact configuration running perfectly in dozens of other locations, so I really don't know what the deal is here.
