02-26-2003 04:15 AM - edited 03-02-2019 05:23 AM
When you setup an Dialer Interface should the bandwidth statement be equal to the number of ISDN Channels available or equal to a single ISDN Channel.
The reason being that we are having issue's where we have "dialer load-threshold 80 either" we find the link doesn't come up when the first ISDN channel is full, it works at load-threshold 30. My theory is that the cisco uses the bandwidth statement to calulate when to bring the next channel up. What is the best practice in this situation?
<example of elements of the dialer config>
interface Dialer1
bandwidth 256
dialer load-threshold 80 either
dialer max-call 4
dialer-group 1
Thanks
02-26-2003 06:37 AM
You are correct. Cisco uses the bandwidth statement to calulate the load and in turn, that is used to bring up multiple channels.
The best method to bring up multiple bri-interfaces is to set the dialer load-threshold to a very low value, such as 1 or 2. Using a higher value will probably result in connections dropping and reconnecting all the time which generates at least the same amount of costs and gives a lower performance.
Regards,
Leo
02-26-2003 10:25 AM
Bandwidth command under the interface will be used to calculate routing matrics/costs only. It will not effect any load calculus set using "dialer load-threshold" . Router should bring up the 2nd channel once the load on the 1st channel increased beyond 80/255.
Keep issuing "sh interface brix:1" to see the load on that channel.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide