Other Network Architecture Subjects

Does anyone know if there is a mib available for the new Catalyst "show vlan counters" command introduced in 12.1(13)E? Since this revision, a customer of mine has found the "show interface vlan" information to be wrong but the "show vlan counters" t...

Is 802.3ad the same thing as FEC/GEC? If not, what are the differences? If I have a non-Cisco switch that supports 802.3ad can I connect that to a Cisco using FEC/GEC?Thanks,Diego

Hi,have some body had problem with RP IPX or NLSP or redistribute rip/IPx en NLSP and vice versa on catalyst msfc and msfc2 ?Actually, all my ipx network are on RIP , and the interconnection to the MAN and the whole MAN ares on NLSP.I'd heart that in...

When examining the syslog output from my 3500xl catalyst switches I see sequence numbers pre-pended to the output even though the 'service sequence-number' is not enabled. For example:1787: Feb 6 08:40:19 est: %SYS-5-CONFIG_I: Configured from conso...

I am using a cisco2610 with a NM-16A module as a terminal server. Attached are 6 routers via their console port. Is it possible to capture cosole alerts/messages from these routers on the terminal server and logg them to a syslog server on our centra...

What is the timeout (Age) of the policy cache entries ?Is there a page on Cisco's site that talks about this ?

Help !! New switch - new native IOS!!I have configured the basics ( after working out a router interface is the management LAN !! ).My router has a vlan1 and vlan2 interface configured and I am running a routing process ( OSPF ) . Both Vlan's show up...

Just upgraded from FDDI to Gigabit E. Dual 6500 switches with Cat OS.Dual 7500 Routers with dual GigE cards port-channelled.Mixed FastE (using Sun QFE cards) & GigE (SysKonnect Fiber Gig) environmentSun environment - E250's, Ultra 60's & some Ultra2...

I read where the 802.1q standard allows trunks to be put on a shared medium. I have always setup trunks in a point-to-point to configuration but we have a need to setup a single trunk between 3 or more devices. The Config we are considering resemble...

Hai,We had configured ACS 5350 which is having a PRI line getting terminated on it.We are having an ACS server 3.1 which is loaded on a win2K where users are created with appropriate permission for dialin.Everyday ACS is sending an Alert message, *...

If I have 2 routes pointing to the same subnet destination, one static & one dynamic, then the static (lower AD value) route will be the one that gets installed in the routing table, right ? But, if say that the the next-hop interface to which the st...

in the following sequence: cd one 5h ed, rme, vpn monitor, common services, router mc, pix mc, ids mc, and security mc. When I attempt to start the app by clicking on the ciscoworks shortcut icon on the desktop, I get an error message indicating tha...

Hi, I have a 3620 (12.1) with Cisco ACS configured for callback option. The Client dials in ok, and you are prompted for the callback number, if you press ok, you will be called back without any problem but you have another option to press ESCAPE i...

I have at least 10-20 routers (not always the same ones) at any given time that end up on the Import Status list with so-called "attribute" errors. I re-enter the proper settings into RME and stil the login fails. Why doesn't RME make more than one a...