05-15-2003 09:55 AM - edited 03-02-2019 07:22 AM
I wonder if you could help -
I would like to add the following to an existing Cisco 7507 chassis:
2 x Ethernet
1 x 2MB Leased Line
1 x ISDN PRI
The slot availability on the 7507 is as follows:
Slot0: free
Slot1: CIP2
Slot2: RSP2
Slot3: RSP Blank Carrier
Slot4: Fast Serial Interface Processor - 4 x free ports
Slot5: Ethernet Interface Processor - 2 x free ports
Slot6: free
Based on this, I could support the requirement for 2 x Ethernet on Slot5, and 1 x 2MB Leased Line on Slot4. Is that right...???
If so, what module(s) would I need to support the remaining 1 x ISDN PRI requirement?
Please advise if there are any IOS version, memory, and/or flash constraints for the ISDN PRI module(s) you recommend.
Thanks in advance for your help.
05-15-2003 12:22 PM
You need to have PA-MC-xT1 port adaptor which does supports Channelized T1/PRI etc. Here is the url for more on that PA
http://www.cisco.com/warp/public/cc/pd/ifaa/pa/much/prodlit/portm_ds.htm
1 port card is not available so you need to order for 2 or 4 port and above. For config on that, visit
http://www.cisco.com/univercd/cc/td/doc/product/cable/cab_rout/cfig_nts/4815ds1p/index.htm
05-16-2003 03:42 AM
Thanks for pointing me in the right direction.
I have opted for the following to support 1 x ISDN PRI on this existing 7507 chassis:
VIP2-50
PA-MC-2E1/120
CAB-ADPT-75/120
Does that look OK to you?
Was I right in saying that the 2 x Ethernet and the 1 X 2MB Leased Line requirement can be supported on the current modules?
Also, I would like to upgrade the Enterprise IOS from 11.2(9)P to 12.1(19), which requires 16MB flash and 64MB dram.
At present, I have 16MB flash and 32MB dram, so will need a memory upgrade as follows:
MEM-RSP-32M x 2
S75A-12116
Is this right...???
Thanks for all your help on this.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide