Other Network Architecture Subjects

Dear all,When I attempt update any CW2K packages, the process fails with the following error message:Package installation failed: error in opening zip fileI have CW2K running on a dedicated W2K Server and I believe that everything is up-to-date... I'...

ipm addsrcipm addtargipm editcoll collfilea coll1 10.0.15.241 10.1.28.1 DefaultIpEcho 1 0 Ma coll2 10.0.15.241 10.1.28.1 DefaultUDPEcho 1 0 Ma coll4 10.0.15.241 10.1.28.1 DefaultDLSw 1 0 Ma coll8 10.0.15.241 10.1.28.1 DefaultIpPathEcho 1 0 Ma coll14 ...

The ISP I work for is multihomed and running BGP on both links, we also happen to have two 7206vxr's. Currently we have one 7206 as the main border router and the other not connected at all, same config just powered down and sitting there.. I belie...

I wonder if you could help -I would like to add the following to an existing Cisco 7507 chassis:2 x Ethernet1 x 2MB Leased Line1 x ISDN PRIThe slot availability on the 7507 is as follows:Slot0: freeSlot1: CIP2Slot2: RSP2Slot3: RSP Blank CarrierSlot4:...

The LAN Edge View in my Campus Manager is broken up into several Switchclouds but these switchclouds should be seen as one switchcloud. What can be causing this and how do I resolve it? There is one "mother switch" feeding like 15 edge switches. Eac...

In the Process Status, AclmServer is allways "Running but busy flag set ",and it can not work, what's the matter of it? thanks firstly.

we have two 8 port gigabit switches as Master and slave configuration.and we have 8 2950SX switches. first port 1000Base SX of 2950SX switch is connected to 8 Port Gigabit Master switch and second 1000Base SX connected to the 8 port Gigabit Slave sw...

Does anybody know if there is a maximum to the number of network statements you can use on any one BGP instance on an MSFC?best regards,Daniel,

Hi,we have a problem with a Catalyst 4006 and Cisco View 5.4 in CiscoWorks 2000 Lan Network Management Solution. When we connect the 4006 and then wants to monitor an Interface we dont see any traffic. The graph remains always on zero percent in all ...

We have a Catalyst 6506 with MSFC/PFC. FE 2/1 on the Cat 6506 is a routed (L3) interface used as an uplink to one of our routers. Will applying the following to FastEthernet 2/1 have the desired effect of limiting the output rate on the FE 2/1 inte...

I need a router simulator ,Who can give me one?

I have a question about what is the maximum length supported on the long haul GBICs? I found a table at the Cisco web site that says the max length is 550 meters is this accurate? I under stand mode conditioning patch cords are needed at the ends....

I have recently installed a Cisco 1721 router for 512 kbps internet leased line. I want to install another internet leased line (64kbps)on the same router, but dont want the traffic from s0 to s1 or vice versa. I mean i want the traffic to remain sep...

I have a 7206 and a 2621 connected by point to point over frame-relay. I couldn't get to the 2621 with IP so I decided to check layer 2 connectivity and did a "sh cdp neigh detail" I was surpised to see the 2621 show up as a switch in the capabilit...