Hi,
I have a problem when I am transferring or copying files between two LANs using Windows Network Drives (mapping drives), the files are not transferred or copied completely. I tried changing the MTU from 1500 to 3600 under the serial interfaces on the two routers of each network. The wan encapsulation is FrameRelay, look at the serial interfaces config:
interface Serial0
mtu 3800
no ip address
encapsulation frame-relay IETF
no ip mroute-cache
priority-group 10
frame-relay lmi-type ansi
!
interface Serial0.1 point-to-point
ip address 10.252.130.13 255.255.255.252
no ip mroute-cache
no cdp enable
frame-relay interface-dlci 17 CISCO
!
!
!
priority-list 10 protocol ip high list 101
!
Any idea about how to avoid the interruptions while files are being copied?
Thanks