Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
337
Views
0
Helpful
2
Replies

Management Vlan on a 6500

robertsd4006
Level 1
Level 1

‎03-08-2005 07:47 AM - edited ‎03-02-2019 10:03 PM

How do you configure a management vlan on a 6500 running native IOS? For example, I create a loopback with an IP but when I do a show cdp it shows the IP address of the lowest configured vlan. Is there a way to force the switch to advertise it's loopback - also want to use the loopback for all management services - tacacas, logging etc. Any help would be appreciated. David

Labels:
0 Helpful
2 Replies 2

sstudsdahl
Level 4
Level 4

‎03-08-2005 09:55 AM

I'm not sure about setting CDP to advertise an IP address other than what you are seeing. Typically in a switched environment VLAN 1 is used as the management address of the switch.

As for TACACS and syslog, you can souce TACACS and syslog messages from the loopback interface IP address with the commands:

ip tacacs source-interface

logging source-interface

Steve

0 Helpful

robertsd4006
Level 1
Level 1
In response to sstudsdahl

‎03-08-2005 02:52 PM

Thanks Steve. I will keep digging on the cdp issue.

0 Helpful
Customers Also Viewed These Support Documents