Environment:
Core - C6509 w/ Sup720 Layer3 / Multicast on
Client - C3560 Layer2 / Multicast on
See diagram
I have setup up a VLAN for my lab bench (VLAN211). Multicast for Symantec Ghost v.8.x will not work on this VLAN. If I change the port on the client switch from VLAN211 to VLAN23 (one my other client networks) then everything works fine.
From the 6509:
ip multicast-routing
mls ip multicast flow-stat-timer 9
ip pim send-rp-announce Vlan11 scope 16 group-list 1
ip pim send-rp-discovery scope 16
access-list 1 permit 239.0.0.0 0.255.255.255
interface Vlan11
description Backbone_Servers
ip address 10.1.1.3 255.255.255.0
ip helper-address 10.1.1.11
ip helper-address 10.1.1.111
ip helper-address 10.1.1.66
no ip redirects
ip pim sparse-dense-mode
interface Vlan23
description School_House
ip address 10.2.3.2 255.255.255.0
ip helper-address 10.1.1.11
ip helper-address 10.1.1.111
ip helper-address 10.1.1.66
no ip redirects
ip pim sparse-dense-mode
interface Vlan211
description IT_Bench
ip address 10.2.11.2 255.255.255.0
ip helper-address 10.1.1.11
ip helper-address 10.1.1.111
ip helper-address 10.1.1.66
no ip redirects
ip pim sparse-dense-mode
From the 3560 Client switch this port works:
interface FastEthernet0/1
switchport access vlan 23
switchport trunk encapsulation dot1q
switchport trunk native vlan 23
switchport trunk allowed vlan 23,33
switchport mode trunk
service-policy input WMT-POLICY
priority-queue out
no mdix auto
spanning-tree portfast
From the 3560 Client switch this port does NOT work:
interface FastEthernet0/3
switchport access vlan 211
switchport trunk encapsulation dot1q
switchport trunk native vlan 211
switchport trunk allowed vlan 211,311
switchport mode trunk
service-policy input WMT-POLICY
priority-queue out
no mdix auto
spanning-tree portfast
Anyone got any suggestions?
