Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm using the Cisco VPN client and after my user's authenticate I would like for the Windows AD Login Script to run so their network shares will map on their local machine and run other tasks.Can this be done with the Cisco VPN client and NOT using t...
Environment:Core - C6509 w/ Sup720 Layer3 / Multicast onClient - C3560 Layer2 / Multicast onSee diagramI have setup up a VLAN for my lab bench (VLAN211). Multicast for Symantec Ghost v.8.x will not work on this VLAN. If I change the port on the cli...
I have multiple sites with Cisco 877 routers. These sites are all issued dynamic IP addresses from their ISP's. In my scenario all sites will have their own unique:a) Private IP network (10.16.xxx.0/24)b) Unique isakmp keyI configured one:crypto is...
I am new to the Cisco 877 router. When I connect a computer to one of the four FE ports I am unable to access the router. I am given an IP address by the DHCP scope but I am unable to telnet, HTTP or HTTPS into the router.Suggestions?Thanks,Danny M...
I have a LAN-to-LAN VPN connection between a Cisco 2691V at my main office and a Cisco 831 (DSL) at a remote office. On the other side of the 831 is one HP printer and 3 computers. At night when they power down the computers and printer, the VPN co...
@Hector Gustavo Serrano Gutierrez Thank you for the reply! I compared your screen shot to what I had configured (see screen shot). I set Promiscuous mode to Accept but I did NOT set MAC Address Changes and Forged Transmits to Accept. When I set t...
I wish I could get IPv4 working for OOB management! For the network in VMware where the simulator resides, did you configure a /24 or something smaller? EDIT: Found my issue. I only turned on Promiscuous mode. When I turned on MAC Address Changes...
Having the same issue. Downloaded and installed 5.1-1h. I go through and accept all defaults except for the management interface. I specify an IP on the network and correct default gateway. While other VMs on the same network work, I cannot ping th...
Thank you for the response. Your last sentance is the direction I'm heading. When I turn on my computer at home, I am not connected to anything work related. I log in using the cached credentials. My wireless then authenticates against the Linksy...
It depends upon your users and application. In my warehouse I have one AP350 driving 45+ handheld RF scanners. The RF scanners are mostly 4800 cards and a few 350 cards. The traffic generated by each scanner is very light and the scanners are runn...
