Hello All:
I need a little help regarding multilink. I wasn't involved in the setup don't know too much about it. But I need to change which T1's IP block is being used by the Multilink group. Here is my cuurent config. How do I go abut doing this. Thanks
interface Multilink1
description MUTILINK
ip address 64.148.226.86 255.255.255.252
ip access-group 100 in
ip verify unicast reverse-path
no ip redirects
no ip unreachables
no ip proxy-arp
ip nat outside
ip route-cache flow
no cdp enable
ppp multilink
ppp multilink fragment disable
ppp multilink group 1
hold-queue 300 in
!
interface FastEthernet0/0
description PRODUCTION
ip address 10.0.2.1 255.255.255.0
ip verify unicast reverse-path
ip nat inside
ip route-cache same-interface
no ip mroute-cache
duplex auto
speed auto
hold-queue 450 in
!
interface FastEthernet0/1
description CORP LINK
ip address 10.0.4.1 255.255.255.0
ip verify unicast reverse-path
ip route-cache same-interface
duplex auto
speed auto
!
interface FastEthernet1/0
no ip address
duplex auto
speed auto
!
interface Serial1/0
description 64.148.230.1/24
no ip address
ip verify unicast reverse-path
no ip redirects
no ip proxy-arp
encapsulation ppp
no fair-queue
no cdp enable
ppp multilink
ppp multilink group 1
!
interface FastEthernet1/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial1/1
description 64.148.225.1/26
no ip address
no ip redirects
no ip proxy-arp
encapsulation ppp
no fair-queue
no cdp enable
ppp multilink
ppp multilink group 1
!
interface Serial1/2
description 64.148.224.129/26
no ip address
ip verify unicast reverse-path
no ip proxy-arp
encapsulation ppp
no fair-queue
no cdp enable
ppp multilink
ppp multilink group 1
Thanks in advance
