NAT on 2614 - move from 56kb to a cable modem

[kholford]

Current config:

PC's --> Hub --> 2614 Router --> 56k -->

(NATing)

1. How do I convert from 56k to a cable modem (not a Cisco cable modem)?

2. Where can I find documentation on configuration or hardware needed?

[s-doyle]

If your cable modem has a numbered Ethernet interface, you can gateway your 2614 to that. I have to pickup the DHCP assigned address from my cable provider so you might have to pickup the routers IP address via DHCP. Your cable provider should have resources available to you.