Need 2600 terminal server config

[frank.murray]

I've got a 2610 with a 16-port Async NM that I'm trying to configure as a terminal server (console port of 10 routers and switches).

I've tried using basically the same config from a 2509 that was working as a terminal server, but it's not working on the 2600.

Thanks,

Frank

[deilert]

the line numbers on 2600's are different than 2500's . do a sh line and it will give you the the numbers , below to connect to the first async line you would do

router#telnet 1.1.1.1 2033

sh line

Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int

0 CTY - - - - - 6 8 0/0 -

33 TTY 9600/9600 - - - - - 0 34 0/0 -

34 TTY 9600/9600 - - - - - 0 33 0/0 -

35 TTY 9600/9600 - - - - - 0 819 0/0 -

36 TTY 9600/9600 - - - - - 0 957 0/0 -

37 TTY 9600/9600 - - - - - 0 817 0/0 -

38 TTY 9600/9600 - - - - - 0 741 0/0 -

39 TTY 9600/9600 - - - - - 1 1 0/0 -

40 TTY 9600/9600 - - - - - 0 0 0/0 -

41 TTY 9600/9600 - - - - - 0 283 0/0 -

42 TTY 9600/9600 - - - - - 1 0 0/0 -

43 TTY 9600/9600 - - - - - 1 0 0/0 -

44 TTY 9600/9600 - - - - - 6 2 0/0 -

45 TTY 9600/9600 - - - - - 22 1343 0/0 -

46 TTY 9600/9600 - - - - - 2 0 0/0 -

47 TTY 9600/9600 - - - - - 0 0 0/0 -

48 TTY

[frank.murray]

I'm aware of the line numbering..... something else

isn't configured right.

Thanks,

Frank

[deilert]

what happens when you try to connect ? can you paste it in .