10-03-2003 07:46 AM - edited 03-02-2019 10:46 AM
I've got a 2610 with a 16-port Async NM that I'm trying to configure as a terminal server (console port of 10 routers and switches).
I've tried using basically the same config from a 2509 that was working as a terminal server, but it's not working on the 2600.
Thanks,
Frank
10-04-2003 03:53 AM
the line numbers on 2600's are different than 2500's . do a sh line and it will give you the the numbers , below to connect to the first async line you would do
router#telnet 1.1.1.1 2033
sh line
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
0 CTY - - - - - 6 8 0/0 -
33 TTY 9600/9600 - - - - - 0 34 0/0 -
34 TTY 9600/9600 - - - - - 0 33 0/0 -
35 TTY 9600/9600 - - - - - 0 819 0/0 -
36 TTY 9600/9600 - - - - - 0 957 0/0 -
37 TTY 9600/9600 - - - - - 0 817 0/0 -
38 TTY 9600/9600 - - - - - 0 741 0/0 -
39 TTY 9600/9600 - - - - - 1 1 0/0 -
40 TTY 9600/9600 - - - - - 0 0 0/0 -
41 TTY 9600/9600 - - - - - 0 283 0/0 -
42 TTY 9600/9600 - - - - - 1 0 0/0 -
43 TTY 9600/9600 - - - - - 1 0 0/0 -
44 TTY 9600/9600 - - - - - 6 2 0/0 -
45 TTY 9600/9600 - - - - - 22 1343 0/0 -
46 TTY 9600/9600 - - - - - 2 0 0/0 -
47 TTY 9600/9600 - - - - - 0 0 0/0 -
48 TTY
10-06-2003 07:40 AM
I'm aware of the line numbering..... something else
isn't configured right.
Thanks,
Frank
10-06-2003 08:22 AM
what happens when you try to connect ? can you paste it in .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide