12-30-2002 07:31 AM - edited 03-02-2019 03:51 AM
Hello,
I'm trying to forward VoIP data from the WAN to a LAN IP address via UDP & TCP ports using PAT. I've built the ports using the string below using the IP PAT PORTHANDLER command. The ports appear built when I use the SHOW IP PAT command, but the data doesn't flow to the IP address.
set ip pat porthandler 5189 192.168.1.6
set ip pat porthandler 5199 192.168.1.6
set ip pat porthandler 5200 192.168.1.6
Am I missing a step?
Thanks
01-02-2003 06:23 AM
Take a look through the following link. If you still can't get this setup to work, I would suggest that you re-post with your entire config or open a case with the TAC:
01-02-2003 10:55 AM
Raymong,
Thank you for responding.
I solved the problem. There was another step, I had forgotten to build the IP filter.
set ip filter udp in destination 192.168.1.xxx:5198-5199 accept.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide