Hi
This is a little confusing to me. In a non-broadcast environment that is obvious that you have to configure neighbors manually, by usiing the command:
Router(config-router)#neighbor x.x.x.x
My question is, do you have to give the addtional commands priority or cost after this or just assigning neighbors like above is enough?
That is:
a) Router(config-router)#neighbor x.x.x.x
b) Router(config-router)#neighbor x.x.x.x priority x
c) Router(config-router)#neighbor x.x.x.x cost x
In the above a,b,c which one is actually correct?
I tried with option (a) with a back-toback scenario and it worked. That is why I am confused, as to whether you really need either the option (b) or (c) or both, i.e. (b) & (c)
Thanks in advance!
Omal.
