Other Network Architecture Subjects

My CM find Cisco 12416 and Import those to RME,But when I check RME Import Status. It shows all our Cisco 12416 are "Not Responding Devices".Two of our Cisco 12416(192.168.3.X) devices are direct connect to our CW2K Server(192.168.3.X) .I am sure tha...

Can any body let me know regarding the Cisco Interface types and the default queuing scheme on those interfaces?

I have a couple of questions about the output of this command.The first is how long are match statistics kept.The second is about "check" counters. Documentation says that this counter increments every time a packet is checked again the rule, but it ...

Hi,I hope someone can enlighten me on this concept...On an edge router (connected to ISP) with outside interface dynamic IP address, I turned on SNTP. However, time does not sync because of my inbound ACL which denies almost everything. In my ACL, ...

In the QoS Chapter of the documentation set for the Catalyst 3750 switch, the documentation refers to the 'internal ring' although it doesn't state what the 'internal ring' does. Can someone provide information on the function and purpose of the inte...

Trying to upgrade a 3620 to 12.3(9), boot to new image failed. Here's the log:rommon 2 > dir flash: File size Checksum File name 7650288 bytes (0x74bbf0) 0x3f59 c3620-i-mz.123-9.binrommon 3 > boot flash:c3620-i-mz.123-9.bi...

At present I have about 200 2950 switches on my network.They are running various ios software.I am upgrading yhen to c2950-i6q4l2-mz.121-20.EA1a.bin all is going ok until I try and load the above sofware on to switches running ios version c2950-i6q4l...

Hello,I'm trying to set interface mac address on the Fastethernet interfaces. The switch is an WS-C2924-XL-EN. When I put the mac-address {mac address} command I get an ""mac-address" override is not allowed in this system"In others switches (the sam...

I have encountered a problem that when the devices is removed from the network, I still can see the device is shown in the ANI database in CiscoWork. So how to delete the expired entities in CiscoWork ANI ?

Hello, I am using cisco works on w2k server, i am trying to add a image from router to ciscoworks, but while monitoring the job status i get the following error: TFTP directory unknown. recomonded action, check inetd.conf file.but when i sear...

Hi, I have two switch (2950) connected to one router (2FE) and the switches are connected between to other port too.I can make a load sharing (balancig) the traffic to two switch towars the router.What feacture are use?ThanksMartín

Do the Cisco Catalyst 3550 SMI and EMI switches support NAT technology?