10-11-2012 11:53 AM - edited 03-03-2019 06:47 AM
Hello every one,
we are going to introduce a new office.as we have already running a setup in older one.
we have already an ASA 5510 and a RV042 router in old setup.
Now i purchased 2 3560 48 port switches with enhence image and a 2611xm router. we have a data center on remote location which is connected to us through a MPLS and a site to site VPN.
Now my new design objectives using the ASA 5510,2611xm,3560 and some other L2 switches are;-
i am also attaching the proposed n/w diagram and vlan plan, kindly suggest how to do this
10-13-2012 03:45 AM
hi there i think you put all your tasks list here
anyway i will try to answer as much as i can
Two Independent Internet connectivity like we have two Internet connections so we want to utilize both connections at a single time but at the time of one Internet failure work should not be effected.
see this link can be helpful
https://supportforums.cisco.com/docs/DOC-8313
Failover for L3 switch(manageable) and gateway Firewall and router.
- you can use HSRP in the L3 switches and and static route to the router and ASA for example
- for VPN primary and secondary this is up to you how to configure the IP of the remote access client side
- for primary and secondary Internet link path/link you can use the idea in the link above make sure you consider NATing as well
- for isolating users/wifi .etc this is something you can do by making multiple subinterface in the FW interface trunk it to a L2 switch and make each group of users to use one of the subinterfaces as the default gateway for traffic filtering
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080b81500.shtml
hope this help
if helpful rate
10-14-2012 08:09 AM
Hi each in, you have pasted all project tasks assigned to this project here publicly, this shouldn't be a good practice though. I am just wondering you are the design engineer of this project or this is something you don't know? Have your organization hire Cisco consultant for this project or you are the consultant yourself?
Sent from Cisco Technical Support iPad App
10-14-2012 01:21 PM
Jigar,
this is Cisco's Support community forums where people can ask and discuss questions for real world cases and for learning too
and it is not necessarily need to be a best practice "what you called it" or an officail answer from cisco
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide