NM-1CE1T1-PRI to DB15

[gaattila]

Hi All,

I'd like to connect my E1 interface (RJ48) to DB15 connector at the network end. One or two docs on CCO are mentioning such a cable, but I can't find an RJ45-to-DB15 cable as an orderable product.

Where could I find a sutiable cable?

Thanks,

Attila

[jolmo]

Hi Attila

I think this is the cable you are looking for:

CAB-E1-PRI

Take a look at following document and do a search for " CAB-E1-PRI= ":

http://www.cisco.com/univercd/cc/td/doc/pcat/se____c1.htm#xtocid18

Hope this helps

[gaattila]

Hi,

Thanks for your reply.

This cable was designed to the old NM-1CE1U module, which had DB15 connector on it. The cable was to connect it to an RJ45 type network side interface.

The problem is that the physical connectors are ok, but the DB15 pinout isn't, as far I could read from this doc:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3600/hw_inst/cabling/marcabl.htm#wp37818

Attila