09-26-2006 05:52 AM - edited 03-03-2019 05:14 AM
I configured the following policy map, but i don't see any matches on the map, with the command: show policy-map interface
policy-map X
class y
trust dscp
class Avaya
police 23000000 80000 exceed-action drop
trust dscp
class class-default
police 10240000 80000 exceed-action drop
no switchport
ip address x.x.x.x x.x.x.x
ip directed-broadcast
service-policy input x
ip ospf authentication
ip ospf authentication-key <removed>
load-interval 30
duplex full
speed 100
srr-queue bandwidth shape 0 0 5 11
priority-queue out
no cdp enable
09-26-2006 06:34 AM
Hi,
can you please post your class-map configuration and also info about hardware and IOS version involved. also please post the output of show policy-map interface.
Are you sure there is traffic accross the port? No blocking due to SPT, down, etc?
Thank you. Regards, Martin
09-26-2006 01:53 PM
Hi
this is the infomation you asked,
lass-map match-all BSC-Voice-Data-Enschede
match access-group 103
class-map match-all Avaya
match access-group 120
Service-policy input: x
Class-map: BSC-Voice-Data-Enschede (match-all)
0 packets, 0 bytes
offered rate 0 bps, drop rate 0 bps
Match: access-group 103
Class-map: Avaya (match-all)
0 packets, 0 bytes
offered rate 0 bps, drop rate 0 bps
Match: access-group 120
Class-map: class-default (match-any)
0 packets, 0 bytes
offered rate 0 bps, drop rate 0 bps
Match: any
0 packets, 0 bytes
rate 0 bps
sh ver
System image file is "flash:c3750-ipservicesk9-mz.122-25.SEB1/c3750-ipservicesk9-mz.122-25.SEB1.bin"
this also what read in the release notes:
In software releases earlier than Cisco IOS Release 12.2(25)SE, you can apply a policy map only to a physical port.
In Cisco IOS Release 12.2(25)SE or later, you can apply a nonhierarchical policy map to a physical port or an SVI.
However, a hierarchical policy map can only be applied to an SVI.
Note Do not use the show policy-map interface privileged EXEC command to display classification information for incoming traffic. The control-plane and interface keywords are not supported, and the statistics shown in the display should be ignored.
Regards,
Rijk
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide