03-11-2003 02:01 AM - edited 03-02-2019 05:45 AM
Hi All,
a silly question....
What is the command to set the number of line displayed when you type a SHOW COMMAND.
I have to take the show tech from some routers and I need to have the show output in just one go.
I have used this command before, but I do not remember.
Thanks
Matteo
Solved! Go to Solution.
03-11-2003 03:56 AM
Hi Matteo
If i understand you correct you mean the "terminal lenght (#of lines)" command.
If you make a "terminal lenght 0" and then lets say give a "show running-config" it shows you the whole config at ones.
Hope that helps you
Roger
03-11-2003 03:56 AM
Hi Matteo
If i understand you correct you mean the "terminal lenght (#of lines)" command.
If you make a "terminal lenght 0" and then lets say give a "show running-config" it shows you the whole config at ones.
Hope that helps you
Roger
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide