Hello,
I configured NAT (overload mode) in the router, but there was problem about the connection. The error message and configuration are listed below. Please help.
Debug Error:
2w0d: NAT: address not stolen for 192.168.0.26, proto 1 port 256
2w0d: NAT: failed to allocate address for 192.168.0.26, list/map 1
2w0d: NAT: translation failed (A), dropping packet s=192.168.0.26 d=xxx.xxx.xxx.xxx
Configuration:
ip subnet-zero
!
interface Ethernet0/0
ip address 192.168.0.254 255.255.255.0
ip nat inside
full-duplex
!
interface Serial0/0
ip address 10.1.1.100 255.255.255.0
ip nat outside
encapsulation frame-relay IETF
no ip mroute-cache
frame-relay map ip 10.1.1.1 20
frame-relay map ip 10.1.1.2 21
frame-relay lmi-type ansi
!
interface Serial0/0.1 point-to-point
ip address 10.2.2.2 255.255.255.252
frame-relay interface-dlci 200
!
router bgp 101
no synchronization
bgp log-neighbor-changes
neighbor 10.1.1.1 remote-as 100
!
ip nat pool nat 10.10.10.3 10.10.10.3 netmask 255.255.255.240
ip nat inside source list 1 pool nat overload
ip nat inside source static 192.168.0.1 10.10.10.1
ip nat inside source static 192.168.0.254 10.10.10.2
ip classless
ip route 0.0.0.0 0.0.0.0 10.1.1.2
ip route 192.168.1.0 255.255.255.0 Serial0/0.1
no ip http server
ip pim bidir-enable
!
access-list 1 permit 192.168.0.0 0.0.0.255
Thanks!
Andy
