Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a connection connected a Cisco router and a Juniper Router. After I setup a MRTG server to monitor the interfaces of both routers. I found the MRTG show the traffic utilization is different. The utilization of Cisco seems higher than th...
Hi all,One of my router prompt out below message in every minute. Anyone faced it before and any solution.Apr 28 10:03:44: %SYS-2-CHUNKBADMAGIC: Bad magic number in chunk header, chunk 0 data 61D28528 chunkmagic D0D0D0D chunk_freemagic D0D0D0D-Pro...
Hi all,I have 2 x 3750 stack together and the ios version of them is 12.2(25)SE. I am going to upgrade the IOS. I have upload the IOS to the switch's flash, but I don't know how to make the 3750 load the new IOS after reload. I have checked the link ...
Hi all,I want to ask that if a Catalyst's port are setup to be authenticate by external radius server, can the radius server know which Catalyst port/interface ask for authentication?
Hi Andrew,The interval are the same. I didn't anaylse the traffic, but the sending and receiving of both ends should be the same.The unicast should equally split. And there is no multicast. Also the broadcast traffic should not cause sure big differe...
Maybe the router don't know the remote end connection lost, so the static route still in the routing table. I think one of the solution is you can apply BGP or other routing protocol to let both ends routers to learn the routes.HTH!Andy
Hi,You can check the running config. of your 837 and look for is there any command is "no ip http server". If yes, then just type "ip http server". And it should be ok.
