Hi,
I want to config a trunk port on my switch to override the priority value in any tagged frames. I have read the manual and it seems that this is possible but I cannot seem to figure out the correct syntax for the command that does it.
This is the section from the manual:
--------------------
switchport priority {default default-priority-id | extend {cos value | none | trust} | override}
no switchport priority {default default-priority-id | extend | override}
Syntax Description
default-priority-id The priority number for untagged traffic. The priority is a number from
0 to 7. Seven is the highest priority.
extend Set the 802.1p priority of the appliance.
cos valueOverride the 802.1p priority of devices connected to the
appliance. The cos value is a number from 0 to 7. Seven is the highest
priority. The cos keyword only applies to the 3524-PWR and the
3548 XL switches.
noneThe appliance is not instructed what to do with the priority.
trustSpecify that the appliance should trust (honor) the received
802.1p priority from devices connected to it.
override Override the priority of tagged frames with the default value.
---------------------------
How do I use the "override" argument???
Thanks
Mike