Please help my 2611 IOS always reload!!

[raymondtse]

hi! have any one can help, it is very urgent,

Today I just erase the IOS from 2611 and I tried to restore the IOS from TFTP, after I upload to route, every thing seem fine, but when I reload or turn off and turn on the route, The IOS will restore again, so every time I turn off and on the route all configure will lost again. I need to complete the route setup before next week, anyone know fix this problem?

[Prashanth Krishnappa]

What is your config register set to? Try changing it to 0x2102. Here is how you do it

enable

conf t

config-register 0x2102

end

wr mem

For reload issue, post output of sh ver and is there any crashinfo written?