12-23-2010 09:03 AM - edited 03-03-2019 06:10 AM
I have a RPS 2300 connected to my Cisco 2960 Switches but the switch shows the specified results
Switch3#sh env rpsRPS is FAULTED
Please let me know what can be the issue.
Thanks
01-01-2011 11:51 AM
"RPS is FAULTED" can be seen when the RPS is powered off, is in stand-by mode, or is failed.
Verify that the RPS has its proper power feed.
Verify that the power supplies in the RPS are not failed.
Verify that on the RPS it is in active mode rather than standby.
Look at this reference:
http://www.cisco.com/en/US/docs/switches/power_supplies/rps2300/hardware/installation/guide/rpstrb.html
Go thru the list and I think you will resolve the issue.
........Mike
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community