Other Network Architecture Subjects

Hi,Can someone please help me with configuration of ACL with below requirements.Please set an ACL for the host 10.170.79.120 for all portsIncoming traffic to host 10.170.79.120 is allowed from everywhere.Outgoing traffic from host 10.170.79.120 is on...

I see the WS-SVC-AGM-1-K9  was EOL  Jan 2010What is the suggested Product Migration Option?Also if anyone is using this WS-SVC-AGM-1-K9 I would like some feedbackOur problem is listed below and we are wondering of the WS-SVC-AGM-1-K9 will work ?Look...

would like to know if there is an instance that would make a switch flap and would contribute to high cpu utilization if its only connected to a server.. its port is configured in port channel..and would eventually contribute to flapping if switch is...

Hi,There is a remote server that downloads info from a server here at HQ. When the dowloads start the rxload on the S0/0/0 interface jumps to 98 percent or so; rxload 250/255. I needed to limit the bandwidth utilization between the servers, so I adde...

anyone knows this massage from a WS-C3548-XL-EN ?%LINEPROTO-CLUSTER_MEMBER_1-5-UPDOWN: Line protocol on Interface FastEthern

I'm spreading myself thin on the ground, trawling Forums and Message Boards around telecommunications and CRM/CTI to introduce my publication which provides a complete overview to the Genesys Laboratories Technologies, Solutions, Products and Framewo...

Hi,I'd like to implement QoS feature on ADSL interface.So the upload and download value are different.How can i setup the bandwidth attribute, distinguish upload and download?Conf:Interface fastethernet 4     bandwidth 8000     service-policy output ...

Please I need to know what I will do my CCNP cert was expired.

Hi there.Resently i configure some MC20x20V cards with mac-domain 1/ 2 (one dw for tow upstreams) but the problem is when i whant see the dowsntream utilization in the snmpwalk only i see trafic in the interface downstream interface Cable6/1/0 (for e...

Hi, i cannot make my router to get the correct time from a ntp server.This is the output from the  show ntp associations command192.168.100.65 configured, insane, invalid, stratum 2ref ID 192.168.100.94, time D164632D.40C3760B (17:05:33.252 CDT Thu A...

I have several Catalyst 3550 switches running IOS 12.1(14)EA1. I have observed thefollowing behavior:PC connected to port boots, works fine. Output from "show mac address-table interface f0/8" lists the MAC of the PC. If the PC is quiet on the net...

hi guys!l have my term server 2511 and l was tryng to recovery the password but at the rommon mode, l cannot have any access even when l do confreg 0x2142he brings me tho this: transaction "CONFREG' domaine server  (172.16.15.30)  (172.44.244.10) (17...

I have an 1811 configured with dhcp scope and generally it works correctly. I have a host on the vlan/subnet that the scope is assigned that can receive an IP and all the specifics from the dhcp server. See the pool below:ip dhcp pool 192.168.233.0/2...

Hi All,I have been searching for Visio Stencils for the following hardware:Cisco MCS 7800Ironport C370Ironport S370Any help in finding stencils for these would be greatly appreciated.

Hi, Need help regarding 1841 & 3845 router. We send 30 GB data on 100 Mbps link. First time we use 3845 router for sending the data and 47 Min are required to complete the data, during this link utilization was 100%. After that we send same data thro...